No more cavitation or corrosion damage with Ecoshield

The decision to apply our award-winning Ecoshield hard coating to rudders and thrusters is paying dividends, with a number of shipowners noticing zero cavitation damage and failure compared to equipment coated with other protective systems.

Some of them were new customers, some returning ones. They had experienced firsthand the devastating effect of cavitation when a traditional coating system is used. For this reason they decided to use Ecoshield to ensure lasting protection against corrosion and erosion damage for the rudders, nozzle rings and tunnel thrusters of their vessels.

Ecoshield has been designed to give a very thorough and lasting protection against cavitation and corrosion. If the cavitation cannot pierce the coating then no other damage can occur.

Tests conducted in a flow channel have confirmed that Ecoshield performs extremely well under severe cavitation. These tests were divided into six stages during which the coating was exposed to an increasing pressure drop, creating a growing cavitation force. Even after the last stage no erosion was present on the patch coated with Ecospeed.

Groundbreaking protection for all running gear


Besides offering rudder protection Ecoshield is also suitable for thrusters, azimuth thrusters, azipods, thruster nozzles, thruster tunnels and other underwater ship gear which needs special protection from corrosion. The extra strength coating protects these areas for the service life of the ship. There is no need for recoating or major repair.

Suited for newbuilds and existing vessels


Protection of the running gear of your vessel is best begun at the newbuild phase. When a vessel comes into drydock, maintenance of its stern area, especially cavitation damage repair, can take a long time. There are strict procedures concerning blasting, painting, welding and propeller and stern tube seal work. Painting is then assigned to the end of the schedule. As a consequence it may be rushed or not done at all or else prolong the stay in drydock.

With an Ecoshield application one can avoid these problems from day one because no repaint of the running gear will be needed during drydocking. Ecoshield will remain intact for the lifetime of the vessel and is guaranteed for ten years. At the most, touch-ups amounting to less than 1% of the surface area will be required. Planning the maintenance of the vessel’s stern area therefore becomes much easier.

The newbuild phase is the perfect time to apply Ecoshield. However, the coating can also be used to protect vessels that have been in service for some time and are already facing cavitation and corrosion damage.

Ecoshield’s flexibility makes it easy to adapt the application schedule to the rest of the activities at the shipyard or drydock in a way which does not interfere with them. Overcoating time can be as short as three hours. This means that for smaller surfaces such as rudders or bow thrusters the two required coats can usually be applied in one single day.

Conclusion


Evidence of the success of the product is the number of companies which began by coating a rudder on one ship experimentally and went on to coat other running gear on the same ship and the rudders and running gear of other ships.

Most are converting their entire fleet as a result of seeing the pristine condition of the coated areas after sailing for several years (some well over ten years).

You can give the rudders and running gear of your vessels the same lifelong protection. Contact one of our offices for more information.

Belgian headquarters
+32 3 213 5318
info@subind.net


US Office
+1 727 443 3900
info.us@subind.net

Related product(s):

Ecoshield

Durable protection against cavitation damage for running gear

Show product